Janakiraman Nagarajan

More than 15 years of working experience in oil & gas electrical design industry handled various FEED and EPCM projects. Proficient in Engineering and design knowledge with skill set in Lighting, heat tracing and 3D design softwares.

Client: petrobras brasileiro s.a– P84 FPSO Project, ATAPU, Brazil

 Responsible for Vendor document review of MV Switchboard. 
 Responsible for Vendor document review for Moto compressor – 13MVA. 
 Vendor document review of induction motors upto 2.5MW 
 Technical Bid evaluation and Pre-bid queries solving for EPC contracts. 
 Review of EPC contractor’s documents and drawings. 
 Involved in the preparation of Job Specification Datasheets and Electrical equipment. 
 Preparation of Material Requisition, Evaluation of Vendor offer, and Technical Bid Evaluation for 
Electrical equipment. 
 Preparation of Cable Sizing and Cable schedule. 

Client: Reliance Industries Limited – Dahej Refinery, Gujarat, India

 Performing E-Tap study LF, SC, MS and Relay co-ordinations. 
 Preparation of Single line diagram. 
 Performing Earthing calculations. 
 Preparation of lighting calculation and cable block diagrams. 
 Preparation of ECS IO lists.

Client: Indian Oil corporation limited – Gujarat Refinery, Vadodara, India

 Participation of factory acceptance test for following transformers. 
i) 120MVA Grid transformer – 220kV/33kV. 
ii) Power transformers upto 31.5MVA – 33/6.6kV. 
iii) Distribution transformers upto 2.5MVA – 6.6/0.433kV. 
iv) 6.6kV HT switch gear – Schneider electric. 
 Site acceptance test for various electrical equipment during the erection and commissioning. 
 Providing engineering support to the construction team. 
 Participation in the erection of induction motors. 
 Providing solutions for electrical augmentation during plant shutdown.

Client: Numaligarh refinery limited – Assam, India

 Preparation of Engineering deliverables Load list, Load summary, Cable schedule. 
 Vendor document review of Grid transformers upto 80/100/120 MVA 220/33kV 
 Vendor document review of Power transformers upto 31.5 MVA 33/6.6kV 
 Vendor document review of distribution transformers upto 2.5 MVA 6.6/0.433kV 
 Vendor document review of induction motors upto 2.5MW 
 Technical Bid evaluation and Pre-bid queries solving for EPC contracts. 
 Review of EPC contractor’s documents and drawings. 
 Involved in the preparation of Job Specification Datasheets and Electrical equipment. 
 Preparation of Material Requisition, Evaluation of Vendor offer, and Technical Bid Evaluation for 
Electrical equipment. 
 Preparation of Cable Sizing and Cable schedule. 
 

 Bachelor of Engineering – Electrical and Electronics in K.L.N College of Information Technology | April 2010

 Diploma in Electrical and Electronics Engineering in K.L.N. Polytechnic College First Class | April 2006